Vulcan 900 LED Brake Light and License Plate Kit
- Description
- Additional information
- Reviews (0)
- Product Notices
Description
Clean up the rear fender of your Vulcan 900 with this LED Brake Turn License Plate kit. This product is intended to replace the cluster on the back of the Vulcan 900 stock rear fender. The LED follows the rear design of the Vulcan 900 rear fender which gives your ride a clean custom look. The brightness of the red LED is more than enough at night and it works very well during the day. The kit comes with a red LED brake light with built in turn signals; you have the choice of three different color tubes to hold the red LED. Also included is a 7″ license plate frame (This is a normal USA license plate size, make sure yours is the same size) and a light to shine on your license plate, the kit is finished off with hardware and instructions.
What you need to know:
- The complete rear plastic section on your stock rear fender will be replaced.
- You will have to wire this kit into the stock wire harness. Please see wire diagram above or watch the video below.
- Due to the shape of the rear fender, the turn signals are not as visible as stock. We suggest adding the extra turn signal LED’s for the best results.
- The LED only comes in red, but you can change the color of the tube. There is the function to run this in dual mode, as running lights and brake / turning. The turn signals will flash fast with out a equalizer module.
- The extra LED option comes as two 3.4″ LED strips that can attach to either side of the license plate holder or maybe another place on the back of the motorcycle. These lights can be used for running, turning, or brake. They are red LED lights with your choice of color tubing.
- The 7″ license plate frame fits USA motorcycle issued plates. If you have a different size license plate then 7″ then the supplied frame will not be the right size for you. However you still get the supplied hardware, support tabs and a license plate light.
- This product fits: Vulcan 900 Custom (all years), does not directly fit the Custom or LT models
- Installation time: 1 hr
- Can I install this part, or should I have a professional handle it?
Yes, you can install this if you have some basic garage skills. This does require wiring to your stock wire harness. We take the plug off the stock harness and attach it to our new LED brake light. Professional installation is always advised.
- How bright is the LED?
Excellent at night, which is most important, and very good during the day. Please understand this is a custom item and if visibility is your main concern then we suggest adding more lights to improve this function.
- Can you see the turn signals from the rear?
Not very good, we suggest adding the extra LED’s to other parts of your ride to improve this function.
- Will my turn signals still function as normal?
With this kit the turn signal will blink faster than normal, but this will not hurt anything. You can get a equalizer to slow them down like the stock lights.
Additional information
Weight | 6 lbs |
---|---|
Dimensions | 12 × 8 × 8 in |
LED Tube Color | SMOKED (Red LEDs), CLEAR (Red LEDs), RED (Red LEDs), SMOKED (Red Run, Amber Turn LEDs) |
License Plate color | BLACK, CHROME |
Reviews
There are no reviews yet.